Garmin SA01456Wi_D Manual Page 55

  • Download
  • Add to my manuals
  • Print
  • Page
    / 300
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 54
G1000/GFC700 System Maintenance Manual – C90A/C90GT/C90GTi King Air Page 3-25
190-00682-01 Revision F
3.9 G1000 Software/Configuration Procedure
This section summarizes the procedures required to load software and configuration files to the G1000. It
is intended to work as a central guide for technicians to use while performing maintenance on the aircraft.
In sections of this manual where software is required to be reloaded, these sections will make reference
back to this Section for instructions. The technician should use proper judgment regarding the context of
maintenance required while following this section.
The following diagram depicts an overview of the software/configuration sequence for the G1000 system.
This applies mostly to a new G1000 system which has not previously been powered up and is for
informative purposes only.
GDU 1040A PFDs / GDU 1500 MFD Software Load
Software is first loaded to the MFD and PFDs. From the factory, G1000 units do
not contain useable software or configuration settings. Load software to PFD2
first then MFD and finally to PFD1.
G1000 System Upload Selection
After software is loaded to the MFD and PFDs, the displays should be placed in
configuration mode. Using PFD1, the technician goes to the System Upload
page. From the System Upload page, software files are selected to create an
automated profile to load. Once all desired files are checked, the G1000
automatically loads the selected files in the correct sequence to the LRUs.
G1000 System Software Verification
After software is loaded to the system, the technician verifies that each LRU
reports the correct version and software part number.
G1000 System Configuration Upload Selection
Following G1000 system software upload and verification, the aircraft specific
configuration files, as defined in the general arrangement drawing are loaded.
The aircraft general arrangement drawing will define the configuration files
appropriate to the specific aircraft serial number, STC modifications and
applicable AFMS.
G1000 Configuration Verification
After system configuration files are loaded, the technician verifies that the
correct configuration on the Airframe Configuration page.
Figure 3-17. Software/Configuration Overview
Page view 54
1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 299 300

Comments to this Manuals

No comments