Garmin SA01456Wi_D Manual download pdf (Page 39)

G1000/GFC700 System Maintenance Manual – C90A/C90GT/C90GTi King Air Page 3-9

190-00682-01 Revision F

3.7.1 SET>ACTV Configuration

Throughout the configuration mode pages, there are SET and ACTIVE columns for input/output settings

and other parameters.

SET:

Refers to a setting or group of settings that reside in PFD Internal Memory and/or the

Master Configuration Module.

ACTIVE:

Refers to an ‘active’ setting or parameter currently being used by the LRU. LRUs store

the ‘active’ settings within internal memory.

Data can be manually copied from one column to the other (and consequently from PFD memory to the

LRU memory and vice-versa) by using the following two softkeys, when available:

• SET>ACTV (read ‘Set to Active’) softkey: Allows the installer to send the information in the SET

column (data stored in the master config module) to the ACTV column (data used by LRU).

• ACTV>SET (read ‘Active to Set’) softkey: Causes the LRUs current settings to be copied to the

master configuration module as SET items.

CAUTION:

The ACTV>SET softkey must be used with caution! If an improperly configured unit is

installed, this softkey causes the wrong configuration to replace the correct aircraft

configuration.

SET>ACTV and ACTV>SET Softkeys

SET Column ACTIVE Column

Figure 3-11. SET and ACTV Softkeys and Columns

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 299 300

No comments

Garmin SA01456Wi_D Manual Page 39