Garmin SA01456Wi_D Manual download pdf (Page 266)

Page 7-36 G1000/GFC700 System Maintenance Manual – C90A/C90GT/C90GTi King Air

Revision F 190-00682-01

7.8 GDL 69A XM Data Link

Original GDL 69A is Reinstalled

No software or configuration loading is required if the removed GDL 69A is re-installed. This does not

include units that were returned for repair as their software and configuration files are deleted during the

repair testing process. Continue to the GDL 69A Test (Section 7.8.1).

New Repaired or Exchange GDL 69A is Installed

If a new repaired or exchange GDL 69A is installed, the correct software and configuration files must be

loaded to the unit, then the XM Satellite Radio subscription must be reactivated. See Section 3.9 and the

XM Activation Instructions listed in Table 1-2. Then continue to the GDL 69A Test (Section 7.8.1).

7.8.1 GDL 69A Test

If an XM Satellite Radio subscription has already been activated for the GDL 69A, then power up the

G1000 and go to the AUX – XM INFORMATION page and verify that the GDL 69A is working

properly. Refer to the Cockpit Reference Guide, listed in Table 1-2, for details on XM Radio weather and

music operation.

If the GDL 69A is replaced (new unit), the owner must re-activate the subscription, using the new

GDL 69A’s Radio ID number(s). Refer to the GDL 69A/69AA XM Satellite Radio Activation

Instructions, listed in Table 1-2, for details on the activation process.

As a final operations check, make sure there are no MANIFEST errors shown on the PFD for the

GDL 69A.

If no other service is to be performed, continue to the return-to-service checks in Section 8.

7.9 GSA 80/81 Servos

Original Servo(s) Reinstalled

No software loading is required if the removed servo(s) is re-installed. This does not include units that

were returned for repair as their software and configuration files are deleted during the repair testing

process. Continue to the return-to-service checks in Section 8.

New Repaired or Exchange Servo(s) Installed

If a new repaired or exchange servo is installed, the correct software files and certification gains must be

loaded to the unit. See Section 3.9 and then continue to the return-to-service checks in Section 8.

NOTE

Refer to the appropriate servo installation drawing listed in Table 1-2.

If no other service is to be performed, continue to the return-to-service checks in Section 8.

1 2 ... 261 262 263 264 265 266 267 268 269 270 271 ... 299 300

No comments

Garmin SA01456Wi_D Manual Page 266