Garmin G1000 Mooney M20TN User Manual Page 73

  • Download
  • Add to my manuals
  • Print
  • Page
    / 380
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 72
190-00647-00 Rev. A
Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN
3-3
EIS
1
Engine Manifold Pressure
Gauge (MAN IN)
Displays engine power in inches of Mercury (in Hg)
Turbocharged Aircraft – Maximum manifold pressure range shown in red
2
Tachometer
(RPM)
Shows propeller speed in revolutions per minute (rpm); the red range
indicates propeller overspeed
3
Fuel Quantity Indicator
(FUEL QTY GAL)
Displays the amount of fuel in gallons (gal) for each tank (L and R)
Standard Tanks
– Indicator displays up to 44.5 gal when full (F)
Long Range Tank Option Allows 55 gal per side (110 gal total), although
the indicator range is the same as for standard tanks. The pointers show
tanks as full until the fuel quantity decreases below 44.5 gal.
4
Fuel Pressure Indicator
(FUEL PSI)
M20M only
Shows fuel pressure in pounds per square inch (psi)
5
Fuel Flow Indicator
(FFLOW GPH)
M20R and M20TN
Displays fuel flow in gallons per hour (gph)
6
Oil Pressure Indicator
(OIL PSI)
Engine oil pressure is displayed in pounds per square inch (psi)
M20M only – High pressure caution range indicated in yellow
7
Oil Temperature Indicator
(OIL °F)
Oil temperature is shown in degrees Fahrenheit (°F)
8
Turbine Inlet Temperature
Indicator (TIT °F)
Turbocharged Aircraft
Displays the temperature at the turbine inlet in degrees Fahrenheit (°F)
9
Exhaust Gas Temperature
Indicator (EGT °F)
Normally-aspirated Aircraft
Shows the Exhaust Gas Temperature of the hottest cylinder in degrees
Fahrenheit (°F)
10
Cylinder Head Temperature
Indicator (CHT °F)
Shows the head temperature of the hottest cylinder (number is shown in
pointer) in degrees Fahrenheit (°F)
11
Voltmeter
(VOLTS1 or VOLTS2)
Displays the bus voltage for the selected battery
12
Ammeter
(BAT1 or BAT2 AMPS)
Displays the battery amperage for the selected battery
13
Trim Group (FLAPS, ELEV
TRIM, RUDDER TRIM)
Flap position (UP, T/O, DN) is denoted; when the flaps are in transit
between positions, /// is displayed (see Figure 3-5)
Elevator and rudder trim are displayed on slide bars; the white portions of
the bars represent correct takeoff trim ranges
Flaps UpTakeoff Flaps Flaps Down Flaps In Transit
Figure 3-5 Flap Positions
Page view 72
1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 379 380

Comments to this Manuals

No comments