Garmin G1000 Mooney M20TN User Manual download pdf (Page 200)

5-82 190-00647-00 Rev. A

Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN

GPS NAVIGATION

Figure 5-69 ‘Not Approved for GPS’ Message

Loading an approach procedure using the Active Flight Plan Page Menu:

1) From the Active Flight Plan Page, press the

Key.

2) Highlight ‘Load Approach’

3) Press the

ENT

Key. The APPROACH window is displayed on the ‘PROC – APPROACH LOADING’ Page.

4) Select an approach and press the

ENT

Key. The TRANSITION window is displayed.

5) Select a transition (the ‘VECTORS’ option assumes vectors will be received to the ﬁnal course segment of the

approach and will provide navigation guidance relative to the ﬁnal approach course).

6) Press the

ENT

Key.

7) Highlight ‘LOAD?’ or ‘ACTIVATE?’. ‘LOAD’ adds the approach to the ﬂight plan without immediately using the

approach for navigation guidance. This allows for the original ﬂight plan to continue navigating until cleared for

the approach, but keeps the approach available for quick activation when needed. ‘Activate’ adds the approach

to the ﬂight plan and begins navigating the approach course.

8) If the approach is not approved for GPS, a ‘NOT APPROVED FOR GPS’ messages is displayed with ‘YES’

highlighted. Press the

ENT

Key to acknowledge the message. To cancel the approach, select ‘NO’ and press the

ENT

Key.

LOAD ARRIVAL

A published standard terminal arrival route (STAR) for the destination airport can be loaded into the

ﬂight plan using one of three methods:

• LD STAR Softkey

• PROC Key

• Active Flight Plan Page Options Menu

The loaded arrival replaces the current arrival with the new selection.

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 379 380

No comments

Garmin G1000 Mooney M20TN User Manual Page 200