Garmin G1000 Mooney M20TN User Manual Page 293

  • Download
  • Add to my manuals
  • Print
  • Page
    / 380
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 292
190-00647-00 Rev. A
Garmin G1000 Pilot’s Guide for the Mooney M20M/M20R/M20TN
6-57
HAZARD AVOIDANCE
TROUBLESHOOTING
The TIS system performs an automatic test during power-up. If the system passes the power-up test, the
standby screen is displayed on the Traffic Map Page. If the aircraft is airborne during the test, traffic is displayed
on the Traffic Page in the operating mode.
If the system fails the power up test, one of the following messages displays:
‘NO DATA- Indicates that data is not being received from the transponder. Contact the service center
or Garmin dealer for corrective action.
‘DATA FAILED’ - Indicates that data is being received from the transponder, but a failure was detected in
the data stream. Contact the service center or Garmin dealer for corrective action.
‘FAILED’ - Indicates that the transponder has failed. Contact the service center or Garmin dealer for
corrective action.
To change the map range, turn the
Joystick clockwise to zoom out or counter-clockwise to zoom in. Map
ranges are 2 nm, 6 nm, and 12 nm.
OPERATING MODE
Once the aircraft is airborne, the system switches from standby mode to operating mode. The G1000
displays ‘TIS OPERATING’ in the upper left-hand corner and begins to display traffic on the Traffic Map Page.
The TIS Traffic Advisory (TA) alerts the pilot to intruding aircraft.
Once the aircraft is on the ground the system switches from operating mode to standby mode. The Traffic
Map Page displays ‘STANDBY’. The pilot can use the page menu or softkeys to switch between Standby
(STBY) and Operating (ON) modes and manually override automatic operation.
Switching between operating modes:
1) Press the
STANDBY
or
OPERATE
Softkey to switch between modes. ‘TIS STANDBY’ or ‘TIS OPERATING’ is
displayed in the status box located in the upper left corner of the Traffic Map Page.
OR:
1) Press the
MENU
Key. The page menu displays ‘Standby Mode’ or ‘Operate Mode’.
2) Press the
ENT
Key on the desired selection.
Page view 292
1 2 ... 288 289 290 291 292 293 294 295 296 297 298 ... 379 380

Comments to this Manuals

No comments