Garmin Software Version 0648.02 User's Guide Page 47

  • Download
  • Add to my manuals
  • Print
  • Page
    / 142
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 46
Garmin G1000 Cockpit Reference Guide for the Piper PA32
4-5
SECTION 4 – NAV/COM &
TRANSPONDER
Altitude Mode (Automatic or Manual)
Altitude Mode is automatically selected when the air
-
craft becomes airborne. Altitude Mode may also be se-
lected manually by pressing the ALT Softkey.
All transponder replies requesting altitude information
are provided with pressure altitude information.
ALT Mode (Mode C
Altitude Reporting)
Figure 4-13 Altitude Mode
Reply Status
When the transponder sends replies to interrogations,
an “R” indication appears momentarily in the reply status
field.
Figure 4-14 Reply Indication
Reply
Indication
Code Selection
VFR Code Selection
1)
Press the
XPDR
Softkey to display the
transponder Mode Selection softkeys.
2)
Press the
VFR
Softkey to enter the VFR code.
Pressing the
VFR
Softkey again restores the
previous identification code.
NOTE: The pre-programmed VFR Code is set at
the factory to 1200.
Enter Code Using Softkeys
1)
Press the
XPDR
Softkey to display the
transponder Mode Selection softkeys.
2)
Press the
CODE
Softkey to display the
transponder Code Selection softkeys, which
includes the digit softkeys.
3)
Press the appropriate digit softkeys to enter
the code in the four-digit code field of the
Transponder Status Box. When the last digit
is entered, the transponder code becomes
active.
When entering a code, press the
BKSP
Softkey
as needed to back up and change code
digits.
Enter Code Using the FMS Knob
1)
Press the
XPDR
Softkey to display the
transponder Mode Selection softkeys.
2)
Press the
CODE
Softkey to display the
transponder Code Selection softkeys, which
includes the digit softkeys.
3)
Turn the small FMS Knob to enter the first two
digits.
4)
Turn the large FMS Knob to place the cursor
in position to change the second two digits.
5)
Turn the small FMS Knob to enter the second
two digits.
6)
Press the ENT Key to activate the code
immediately, or wait 10 seconds and the code
will become active.
Page view 46
1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 141 142

Comments to this Manuals

No comments