Garmin Software Version 0648.02 User's Guide Page 23

  • Download
  • Add to my manuals
  • Print
  • Page
    / 142
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 22
Garmin G1000 Cockpit Reference Guide for the Piper PA32
1-11
SECTION 1
SYSTEM OVERVIEW
Jeppesen Aviation Database
NOTE: After the aviation database is installed,
the card may be removed after loading the
update to each LRU.
Updating the Jeppesen aviation database:
1)
With the G1000 System OFF, insert the SD card
containing the aviation database update into the
top card slot of the PFD to be updated (Label of
SD card facing left).
2)
Turn the G1000 System ON. A prompt similar to
the following is displayed in the upper left corner
of the PFD:
Figure 1-11 Database Update Prompt
3)
Press the ENT Key to start the database update.
A prompt similar to the following is displayed:
Figure 1-12 Database Update Confirmation
4)
After the update completes, the PFD starts in
normal mode.
5)
Turn the G1000 System OFF and remove the SD
card.
6)
Repeat steps 1 through 4 for the MFD. The MFD
and PFD databases are now updated. Remove
the SD card when finished.
7)
Verify that the correct update cycle is loaded
during startup of the MFD.
Garmin Databases
Since these databases are not stored internally in the
MFD or PFD, a Supplemental Data Card containing iden
-
tical database versions must be kept in each display unit.
NOTE: The data contained in the terrain and
obstacle databases comes from government
agencies. Garmin accurately processes and
cross-validates the data, but cannot guarantee
the accuracy and completeness of the data.
1)
Insert one SD card in the bottom card slot of
the MFD and one in the bottom card slot of the
PFD. The SD card containing the ChartView or
FliteCharts database must be inserted into the
bottom slot on the MFD.
2)
Apply power to the G1000 System. View the
MFD power-up splash screen. Check that the
databases are initialized and displayed in the
window of the splash screen. When updating the
terrain and FliteCharts databases, an ‘in progress’
message may be seen. If this message is present,
wait for the system to nish loading before
verifying the correct databases are initialized,
then proceed to step 3.
Page view 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 141 142

Comments to this Manuals

No comments