Garmin 10v Installation Manual download pdf (Page 6)

6 GHP 10V Installation Instructions



➊

➋

➌

➍

➎

➑

➐

➏

  

➊

GHC 20

➋

GHC 20 data cable Route the yellow wire to the location where you plan to install the GHC 20 (page 8)

➌

NMEA 2000 network The GHC 20 and the CCU must be connected to the NMEA 2000 network using the included T-connectors

(page 9).

If there is not an existing NMEA 2000 network on your boat, you can build one using the supplied cables and

connectors (page 10).

➍

NMEA 2000 power cable This cable should be installed only if you are building a NMEA 2000 network. Do not install this cable if there is an

existing NMEA 2000 network on your boat (page 10).

The NMEA 2000 power cable must be connected to a 9–16 Vdc power source.

➎

CCU Mount the CCU with the cables pointing straight down (page 7).

➏

CCU power cable The CCU can be connected to a 12-24 Vdc power source. The black wire from the GHC 20 data cable must be

connected to the same ground as this cable (page 8).

➐

CCU interconnect cable In order for the autopilot to turn on, the yellow wire from this cable must be connected to the yellow wire from the

GHC 20 data cable.

The orange and blue wires from this cable must be connected to the alarm (page 7).

➑

GHP 10V Autopilot

Gateway

1 2 3 4 5 6 7 ... 20

No comments

Garmin 10v Installation Manual Page 6