Garmin 10v Installation Manual download pdf (Page 19)

GHP 10V Installation Instructions 19



Detach this checklist from the installation instructions and use it to assist with the GHP 10V installation process.

Read all installation instructions before installing the GHP 10V. Contact Garmin Product Support if you have any questions during the installation

process.

1. Refer to the diagram and notes starting on page 6 to understand the necessary electrical and data connections.

2. Lay out all of the components rst. Check the cable lengths. Obtain extensions if necessary.

3. Mount the CCU by following the directions starting on page 5. Mount the CCU in a location free of magnetic interference. Use a

handheld compass to test for magnetic interference in the area. Mount the CCU in the bracket so that the wires hang straight

down.

4. Mount the GHC 20 by following the directions starting on page 5.

5. Mount the Autopilot Gateway by following the directions on page 7.

6. Connect the Autopilot Gateway to the Volvo multilink bus (page 8).

7. Connect the Autopilot Gateway to the CCU using the CCU interconnect cable (page 8).

8. Connect the GHC 20 and the CCU to a NMEA 2000 network. Connect an optional NMEA 2000-compatible GPS device to the NMEA

2000 network (page 9).

9. Connect the yellow wire on the GHC 20 data cable to the yellow CCU signal wire on the CCU interconnect cable and the black

wire on the GHC 20 data cable to CCU ground. Connect an optional NMEA 0183-compatible GPS device to the GHC 20 if a

NMEA 2000-compatible GPS device is not available (page 10).

10. Congure the GHP 10V system by completing the Sea Trial Wizard (page 11).

1 ... 18 19 20

No comments

Garmin 10v Installation Manual Page 19