Garmin 10v Installation Manual

GHP 10V Installation Instructions 1To obtain the best possible performance and to avoid damage to your boat, instal

10 GHP 10V Installation InstructionsNoticeYou must connect the included NMEA 2000 power

GHP 10V Installation Instructions 11The GHP 10V must be congured and tuned to your boat dynamics and motor conguration. Use t

12 GHP 10V Installation Instructions1. Drive the boat in one direction with the autopilot engaged (h

GHP 10V Installation Instructions 13The following three connection diagrams are examples of different situations

14 GHP 10V Installation Instructions  CCU Dimensions 3 19/32 in. diameter (91.4 mm)Weight 5.6 oz. (159 g)Te

GHP 10V Installation Instructions 15When connected to optional NMEA 0183-compatible devices, the GHC 20 uses the following NMEA

16 GHP 10V Installation Instructions  NMEA Setup Reversed XTE If the connected NMEA 0183 GPS unit sends the incorrect steer

GHP 10V Installation Instructions 17➊➊Up, when installing on a vertical surface

GHP 10V Installation Instructions 19Detach this checklist from the installation instructions and use it to assist with

2 GHP 10V Installation Instructions Registering Your Device ...

© 2013 Garmin Ltd. or its subsidiariesAll rights reserved. Except as expressly provided herein, no part of this manual may be reproduced, copied, tran

GHP 10V Installation Instructions 3The GHP 10V autopilot system consists of multiple components, each sold s

4 GHP 10V Installation InstructionsThe NMEA 2000 cables connect the CCU and the GHC 20 to the NMEA 2000 network. Eithe

GHP 10V Installation Instructions 5Before installing the GHP 10V autopilot system, you must plan where all the components wil

6 GHP 10V Installation Instructions➊➋➌➍➎➑➐➏  ➊GHC 20➋GHC 20 data cable Route

GHP 10V Installation Instructions 7After you have completely planned the GHP 10V installation on your boat, and have satised

8 GHP 10V Installation Instructions1. Open the Volvo multilink bus and disconnect the multilink breakout cable.2. C

GHP 10V Installation Instructions 9NoticeIf you have an existing NMEA 2000 network on your boat, it shou