Garmin RS-232 User Manual download pdf (Page 22)

The values displayed can be adjusted with the ADD/FULL toggle

switch. ADD increments the value, and FULL decrements the

value. As you hold ADD or FULL, the scrolling rate will increase

up to a maximum speed.

If you wish to jump directly into the fastest scrolling speed, while

holding the ADD/FULL toggle switch, press the fuel USED or fuel

REM button.

Once the desired values are selected, press and hold the

TEST/ENTER button while the upper window displays a count

down from 5 to 1. When the lower left window displays “SET,”

release the TEST/ENTER button.

Note: It is recommended that you leave the unit powered up for at

least one minute before turning the unit off. Reset switches 1 and 2

to Operate Mode (F,F) and reboot (Power ON). Then confirm the

settings. The Manual Entry Pages will be displayed as follows.

Symbols in ( ) represent 7 segment characters actually displayed.

Field K-factor adjust for Software Versions 60.08.72+

1. Remove the Microflo-L from the instrument panel.

2. Remove the red label from the right side of the Microflo-L

and save it to be put back in place after the adjustment is

complete.

3. With a small, flat blade screwdriver change the second

hexadecimal switch (SW2) from the face of the Microflo-L

from position “F” to position “E”.

4. Reconnect the unit to the aircraft harness and turn the

aircraft master switch on. An “L” for the left engine will

appear on the left side of the left window, and the K-factor

minus the least significant digit on the right side of the

window.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

No comments

Garmin RS-232 User Manual Page 22