Garmin RS-232 User Manual download pdf (Page 17)

5. ERROR MESSAGES

ERROR 1:

Dues to the necessity of Group 1 settings, if the Flow Meter is set to

Operate Mode and the checksum of Group 1 is bad, the display will

flash: E1.

This refers to Error 1, Group 1. The flow meter will not continue to

function after this point, and will continue flashing E1, alerting the

flow meter must be serviced.

ERROR 2:

The Flow Meter will still be accurate and operate under NON-

LORAN pages if the checksum of Group 2 is bad. In this case,

under any Loran page, the Loran information will be replaced by

E2.

This display refers to Error 2, or Group 2. This is to alert the pilot

that the Flow Meter does not have valid Loran and Output

selections, and therefore, can not rely on Loran and Output

information.

NOTE: Remember it is possible to set group settings without

having to be in entry mode, therefore, this error can be fixed by

going into Manual Entry Mode.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

No comments

Garmin RS-232 User Manual Page 17