Garmin RS-232 User Manual download pdf (Page 24)

Display Description

*L xxxxx = Left K-factor (where xxxxx is valid from 0 to 20,000. These are in 10s. A

setting of 1234 would be a K-factor of 12,340)

*R xxxxx = Right K-factor (as above).

*A xxxxx = Left Fuel Flow Offset Frequency (Hz) for Analog Models Only

*B(b) xxxxx = Right Fuel Flow Offset Frequency (Hz) for Analog Models Only

*U x = Fuel Units are defined by the part number. Do not adjust these, as improper

burn indication will occur.

0 = Gallons

1 = Liters

2 = Lbs 5.8

3 = Lbs 6.7

4 = Kilograms

5 = Lbs 6.5

6 = Lbs 6.35

*E x = Engine Type:

0 = Single

1 = Twin

*C x = Low Flow Cutoff:

0 = Off

1 = On

NOTE: Will not display fuel flow until a rate of 50 pounds per hour is

reached.

O x = GPS/Output Type: Only used with Microflo-L, which selects the serial data

output type by GPS or Loran Manufacturer.

0 = none

1 = Allied Signal, KLN series

2 = AirData, used to communicate with a Shadin Airdata

computer

3 = Arnav, used to communicate with most Arnav Loran or GPS

4 = Trimble, used to communicate with most Trimble Loran

or GPS

5 = Generic, used to communicate with most Garmin GPS

I X = Loran Input:

0 = Off

1 = On

D(d) x = Endurance Warning Time:

0 = 45 minutes

1 = 5 minutes

2 = 10 minutes

3 = 20 minutes

4 = 30 minutes

F x = Filter Type:

0 = Injector

1 = Carburetor, for engines equipped with a carburetor

) x = Ignore Loran Warnings

0 = No (default) setting used with Shadin Flow Meter. With

GPS, set to zero (0).

1 = Ignore Loran Warnings. Used with Foster Loran only.

S xxxx = Low Fuel Level: Displayed in same units of measure as the flow rate.

* = Group 1 information ( ) = actual letter display. All others displayed as shown

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30

Comments to this Manuals

No comments

Garmin RS-232 User Manual Page 24

Comments to this Manuals

Related products and manuals for Navigators Garmin RS-232