Garmin RS-232 User Manual download pdf (Page 10)

6. After reaching the correct total usable fuel figure, press the

ENTER/TEST button and the computer will store that number

as full fuel. The word “FUL” disappears and the computer will

return to the operating mode. Release the ADD/FULL toggle

switch.

7. To verify that the data is stored properly, press the

ENTER/TEST button. The computer will run a diagnostic

check and then display “GOOD”. If the test is successful, it will

display the maximum usable fuel.

NOTE: Do not turn the power off to the computer for

approximately one minute. This will ensure that the unit

has enough time to store the proper figures into the

program.

2.2 PREFLIGHT CHECK

Initiate the diagnostic software built in to the system by pressing the

ENTER/TEST button; the program checks the hardware and the

display. If the test is successful the word “GOOD” will appear in

the display window; if not, the word “BAD” appears. The system is

considered unserviceable until corrective action is taken.

At the end of the test routine the system will display the following:

1. Software version

2. The K-factor setting (pulse count/gallon)

3. The display units (Gal., LB 5.8, LB 6.7, etc.) as part of checking

the internal settings.

Move the USED/REM toggle switch to the USED position. The

system will display the fuel used since last fuel entry or fuel used

since last reset.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

No comments

Garmin RS-232 User Manual Page 10