Garmin Appliance Data User's Guide Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 100
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
6
Part One: Section 2
TIS Controls and Display
Traffic Ground Track
Traffic ground track is indicated in the 400W/500W
display by a “target track vector”, a short line displayed
in 45° increments, extending in the direction of target
movement.
Traffic Target Track Vector.
Traffic Warning Window
When the unit is on any page (other than the NAV
Traffic Page or when a TAWS/Terrain, or Dead Reckoning
pop-up is displayed) and a traffic threat is imminent, the
Traffic Warning Window is displayed. The Traffic Warning
Window shows a small thumbnail map which can take
the user to the Traffic Page by pressing ENT, or go back to
the previous page by pressing CLR.
Traffic Warning Window
NOTE: The Traffic Warning Window is disabled
when the aircraft ground speed is less than 30
knots or when an approach is active.
Traffic Page
TIS Traffic data are displayed on two 400W/500W
Series unit pages, the Traffic Page and the Map Page.
The 500W Series unit can also be configured to display
a traffic thumbnail window below the VLOC frequency
window. Unlike other forms of traffic, TIS traffic does
not require heading data to be valid on the map. The only
difference between TIS and other traffic data occurs on the
Traffic Page. If heading is available, then the traffic data
are compensated and displayed as heading-up. If it’s not
available, the Traffic Page is a track-up display. It is labeled
on the upper portion of the Traffic Page.
Traffic Page Display Range
Various display ranges can be selected for optimal
display of TIS traffic information.
To change the display range on the Traffic Page:
Press RNG to zoom through the range
selections which are: 12/6 NM, 6/2 NM, and
2 NM.
190-00356-30 Rev L
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 99 100

Comments to this Manuals

No comments