Garmin GNS 530 User Manual download pdf (Page 263)

GNS 530(A) Pilot’s Guide and Reference

190-00181-00 Rev. H

SECTION 16 – MESSAGES,

ABBREVIATIONS, & NAV TERMS

16-7

Select VLOC on CDI for approach - The

aircraft is inbound and within 3 nm of the FAF;

and the active approach is not a GPS-approved

approach. Verify that the VLOC receiver is tuned

to the proper frequency and press the CDI Key to

display ‘VLOC’ (directly above the CDI Key).

Set course to [###]° - The course select for

the external CDI (or HSI) should be set to the

speciﬁed course. The message only occurs when

the current selected course is greater than 10°

different from the desired track.

Steep turn ahead - This message appears

approximately one minute prior to a turn in one

of the following three conditions: 1) the turn

requires a bank angle in excess of 25° in order

to stay on course, 2) the turn requires a course

change greater than 175°, or 3) during a DME arc

approach the turn anticipation distance exceeds

90 seconds.

Stored data was lost - All user waypoints, ﬂight

plans, and system settings have been lost due to a

memory battery failure or system reset.

Terrain - See Section 12.3 and 13.3 for complete

lists of TAWS and TERRAIN related Alerts and

Annunciations.

Terrain conﬁguration conﬂict - The hardware

conﬁguration does not match the terrain software

conﬁguration. The operational status of the

terrain components is unknown and the unit

should be returned to a Garmin dealer for service.

Terrain conﬁguration has changed - The

software has detected a change in the terrain

conﬁguration.

Terrain has failed - The terrain functionality

self-test has failed. The operational status of the

terrain components is unknown and the unit

should be returned to a Garmin dealer for service.

Timer has expired - The count down timer has

reached zero.

Trafﬁc device needs service - Either the TCAD

battery or the TCAD interrogation device has

failed. If the message persists, contact a Garmin

dealer for assistance.

Unit conﬁguration has changed - The GNS

530 has detected a failure (during initial power

up) in its system conguration. Some system

components may be unusable. Try cycling power

off and back on. If the message persists, contact a

Garmin dealer for assistance.

User card format unknown - A data card has

been inserted, but the format of the card is not

recognized.

VLOC has failed - The GNS 530 has detected a

failure in its VLOC receiver. The VLOC receiver is

not available and the unit should be returned to a

Garmin dealer for service.

VLOC is not responding - Internal system-

to-system communication between the main

processor and the VLOC receiver has failed.

Operational status of the VLOC receiver is

unknown and the unit should be returned to a

Garmin dealer for service.

VLOC needs service - The GNS 530 has

detected a failure in its VLOC receiver. The VLOC

receiver may still be usable, but the unit should be

returned (at the earliest convenience) to a Garmin

dealer for service.

1 2 ... 258 259 260 261 262 263 264 265 266 267 268 ... 287 288

Comments to this Manuals

No comments

Garmin GNS 530 User Manual Page 263

Comments to this Manuals

Related products and manuals for Air equipment Garmin GNS 530