Garmin GPSMAP 130 User Manual download pdf (Page 75)

Installing & Removing G-chart Cartridges

The GARMIN GPSMAP 130 system uses G-chart offshore or inland cartography

to display digital charts on-screen. G-chart cartridges are installed in the card slot

located at the bottom right of the GPSMAP unit. G-chart cartridges may

be installed or removed at any time, whether the unit is on or off.

To install a G-chart cartridge:

1. Open the cartridge door.

2. Insert the card (label facing front and G-chart logo at top) into the slot.

3. Use your thumb to firmly push the cartridge into place (until the cartridge will not go any

further into the unit). If your GPSMAP 130 is on, a confirmation tone will sound when the

cartridge has been properly installed and accepted.

4. Close the cover.

If you insert a G-chart cartridge and get a ‘card format not recognized’ message, try

removing the card and reinserting it. If the card is still not recognized, contact the

dealer you purchased it from for assistance. G-chart cartridges are not waterproof,

should not be exposed to moisture or excessive static charges, and should be stored

in the anti-static bag supplied with the cartridge.

To remove a G-chart cartridge:

1. Open the cartridge door.

2. Grasp the card at the bottom groove and pull firmly.

3. If your GPSMAP is on, a confirmation tone will sound when the G-chart

cartridge has been removed.

SECTION

G-CHARTS

Installing &

Removing G-charts

gps 130 7/23/98 9:22 AM Page 65

1 ... 74 75 76 ... 94

No comments

Garmin GPSMAP 130 User Manual Page 75