Garmin TR-1 Instruction Manual download pdf (Page 7)

Cylinder Rod Eye

Place the Rod Eye (item 31) over the

vertical pin in the Rod Eye Mounting

Bracket (item 2) as shown. (Leave

the cylinder attached.) Put the plastic

Washer (item 14) on the pin against

the Rod Eye and install the Medium

Hair Pin Cotter (item 9) through the

hole in the vertical pin. Turn the

Cylinder (item 34) Fittings (item 35)

up. The cylinder back end cap mount

should freely align against the top

surface of the mounting ear of the

Cylinder Mounting Angle Assembly

(item 3). If it does not, adjust the set

screws in the Carrier for the Rod Eye

Mounting Bracket (item 1) so that they

do. Be sure the set screws are tight

when you are done.

Cylinder End Cap

Line the hole in rear end cap of

the Cylinder with the hole in the

top of the Cylinder Mounting

Angle Assembly. Slide the Clevis

Pin (item 10) through both hole

from the top. Put the second Hair

Pin Cotter (item 12) through the

cross holes in clevis.

Figure 11

Figure 12

7

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments