Garmin TR-1 Instruction Manual download pdf (Page 6)

Mounting The Angle

Replace the washers on the last two screws removed with the star Lock washers (item 7).

Put a little thread lock on the ends of them and install them through the cylinder mounting angle assembly

(item3) and back into the motor as shown in gure 9. (Angle with the label facing you right side up.)

Tighten the screws. Replace the lower vibration isolator shroud removed at gure 7.

A little thread lock should be used on these screws also.

Remove Vertical Screws.

Next, use the 12mm wrench to

remove the two port side screws

shown in gure 8.

Figure 9

Figure 8

1 2 3 4 5 6 7 8

No comments

Garmin TR-1 Instruction Manual Page 6