Garmin Pilatus PC_6 User's Guide Page 377

  • Download
  • Add to my manuals
  • Print
  • Page
    / 404
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 376
190-00870-00 Rev. B
Garmin G950 Pilot’s Guide for the Pilatus PC-6
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
365
APPENDIX B
Since these databases are not stored internally in the PFD or MFD, a Supplemental Data Card containing
identical database versions must be kept in each display unit. A Supplemental Data Card should be inserted
into the bottom card slot of the PFD and the MFD and not removed except for updating the card.
The Garmin database updates can be obtained by following the instructions detailed in the ‘Aviation Databases’
section of the Garmin website (www.garmin.com). Once the updated files have been downloaded from the
website, a PC equipped with an appropriate SD card reader is used to unpack and program the new databases
onto the existing Supplemental Data Cards. The following equipment is required to perform the update:
•Windows-compatiblePCcomputer(Windows2000orXPrecommended)
•SDCardReader:SanDiskSDDR-93,SanDiskSDDR-99,Verbatim#96504,orequivalent
•UpdateddatabaseobtainedfromtheGarminwebsite
•Existing010-00330-42SupplementalDatabaseSDCardsfrombothPFDandMFD
Updating Garmin databases:
1) Copy the data to the appropriate data cards.
2) Insert one SD card in the bottom card slot of the MFD and one in the bottom card slot of each PFD.
3) Apply power to the G950 System. View the MFD Power-up screen. Check that the databases are initialized
and displayed on the Power-up screen. When updating the terrain database, an ‘in progress’ message may be
seen. If this message is present, wait for the system to finish loading before verifying the correct databases are
initialized, then proceed to step 3.
Figure B-3 Database Information on the Power-up Screen
4) Acknowledge the Power-up Page agreement by pressing the
ENT
Key or the right most softkey.
5) Use the FMS Knob to select the AUX - System Setup Page.
6) Select the DBASE Softkey to place the cursor in the ‘DATABASE’ box.
7) Turn the FMS Knob to scroll through the list and check that all databases are current and there are no errors.
8) Power down the G950.
Page view 376
1 2 ... 372 373 374 375 376 377 378 379 380 381 382 ... 403 404

Comments to this Manuals

No comments