Garmin GPSMAP 4212 User Manual Page 43
- Page / 84
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
GPSMAP 4000 Series Owner’s Manual 39
Conguring the Device
ConfiGUrinG
the deViCe
Water Temp—sets an alarm to sound when the transducer reports a temperature that is 2°F (1.1°C)
above or below the specied temperature.
Fish—sets an alarm to sound when the chartplotter detects a suspended target of the specied
symbols.
— sounds an alarm for all sh sizes.
— sounds an alarm for medium and large sh only.
— sounds an alarm for large sh only.
Setting Weather Alarms
NOTE: You must have a subscription to XM WX Weather and a Garmin XM WX Weather receiver
(such as a GDL 30A) connected using the Garmin Marine Network to view weather information. See
page 58 for more information.
1. From the Home screen, select Congure > Alarms > Weather.
2. Turn the following alarms on or off: marine, tornado, severe storm, ood, or ash ood.
Setting the Total Fuel Onboard Alarm
NOTE: To receive fuel-level information, your chartplotter must be connected to an external fuel
sensor, such as the Garmin GFS 10.
You can congure your chartplotter to sound an alarm when the total amount of remaining onboard
fuel reaches the level you specify.
To enable the Total Fuel Onboard alarm and set the fuel alarm level:
1. From the Home screen, select Congure > Alarms > Fuel > Total Fuel Onboard > On.
2. Use the Rocker to indicate the fuel level at which the alarm should sound.
To disable the Total Fuel Onboard alarm:
From the Home screen, select Congure > Alarms > Fuel > Total Fuel Onboard > Off.
Conguring My Boat
From the Home screen, select Congure > My Boat.
Keel Offset—offsets the surface reading for the depth of a keel, making it possible to measure depth
from the bottom of the keel instead of from the transducer location. Enter a positive number to offset
for a keel. You can enter a negative number to compensate for a large vessel that may draw several
feet of water.
Temp Offset—set the temperature offset for the temperature sensor of your transducer.
Calibrate Water Speed—calibrates a speed-sensing device. Follow the onscreen directions for
calibration. If you do not have a speed-sensing transducer, this menu does not appear.
NOTE: If the boat is not moving fast enough or the speed sensor is not registering a speed, a “Speed
Too Low” message appears. Select OK and safely increase boat speed. If you get the message again,
stop the boat and make sure the speed-sensor wheel is not stuck. If the wheel turns freely, check the
cable connections. If you continue to get the message, contact Garmin Product Support.
Fuel Capacity—enter the total fuel capacity of all your engines.
- 4000 Series 1
- Introduction 3
- Table of Contents 4
- Getting Started 5
- Turning on the Chartplotter 6
- Turning Off the Chartplotter 6
- Adjusting the Backlight 7
- Adjusting the Color Mode 7
- GettinG 8
- Viewing System Information 8
- Using the Simulator Mode 8
- Understanding the Home Screen 9
- Using Charts 10
- Navigation Chart Settings 11
- Understanding Chart Data 11
- Panning the Navigation Chart 12
- Data Bars 14
- Changing the Chart Appearance 15
- Using Perspective 3D 16
- Using Tracks 17
- Using Radar Overlay 17
- Using BlueChart g2 Vision 19
- Using Mariner’s Eye 3D 20
- Using Fish Eye 3D 21
- Using Fishing Charts 22
- Viewing Aerial Photos 23
- Detailed Road and POI Data 24
- Using Automatic Guidance 24
- Using Combinations 25
- Where To? 27
- Creating and Using Waypoints 29
- Creating and Using Routes 31
- Viewing Information 33
- Viewing Celestial Information 34
- Viewing User Data 34
- Viewing the DSC List 36
- Viewing Engine Gauges 37
- Viewing Fuel Gauges 37
- Viewing Video 38
- Conguring the Device 39
- Conguring Units of Measure 40
- ConfiGUrinG 41
- Setting Alarms 42
- Conguring My Boat 43
- Conguring Other Vessels 44
- Conguring XM Audio 45
- Using the Marine Network 46
- Using Radar 48
- Using Cruising Mode 49
- Using Sentry Mode 49
- Radar Targeting 50
- Adjusting the VRM and EBL 52
- Advanced Radar Conguration 53
- Using Sonar 54
- Understanding the Temp Log 55
- Setting Up Sonar 56
- Advanced Sonar Settings 57
- Adding a DSC Contact 58
- Receiving Distress Calls 59
- Position Tracking 60
- Calling an AIS Target 61
- SinG Xm 62
- Using XM 63
- Viewing Sea Conditions 65
- Viewing Fish Forecasting 67
- Using XM Audio 69
- Appendix 70
- NMEA 0183 and NMEA 2000 71
- Capturing Screenshots 72
- Messages and Alarms 73
- Product Registration 77
- Contact Garmin 77
- Declaration of Conformity 77
- Weather Data Warranty 77
- Software License Agreement 78
Related products and manuals for Navigators Garmin GPSMAP 4212
Navigators Garmin SA01535Wi_D Manual
(314 pages)
(314 pages)
Navigators Garmin Appliance Data User Manual
(26 pages)
(26 pages)
(6 pages)
Navigators Garmin SA01535Wi_D Instruction Manual
(308 pages)
(308 pages)
Navigators Garmin 20 User Manual
(20 pages)
(20 pages)
Navigators Garmin GPS 38 User Manual
(68 pages)
(68 pages)
Navigators Garmin quatix Owner's Manual
(22 pages)
(22 pages)
Navigators Garmin AW119Kx User's Guide
(126 pages)
(126 pages)
© 2020, manymanuals.com. All rights reserved. | 0.104 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals