Garmin GNS 430 User Manual download pdf (Page 180)

172

Timer has expired—The count down timer has reached zero.

Unit configuration has changed—The GNS 430 has detected a fail-

ure (during initial power up) in its system configuration. Some system

components may be unusable. Try cycling power off and back on. If the

message persists, contact your GARMIN dealer for

assistance.

User card format unknown—A data card has been inserted, but the

format of the card is not recognized.

VLOC has failed—The GNS 430 has detected a failure in its VLOC

receiver. The VLOC receiver is not available and the unit should be

returned to your GARMIN dealer for service.

VLOC is not responding—Internal system-to-system communica-

tion between the main processor and the VLOC receiver has failed.

Operational status of the VLOC receiver is unknown and the unit should

be returned to your GARMIN dealer for service.

VLOC needs service—The GNS 430 has detected a failure in its

VLOC receiver. The VLOC receiver may still be usable, but the unit

should be returned (at your earliest convenience) to your GARMIN

dealer for service.

MESSAGES,

aBBREVIATIONS

& nav tERMS

VLOC remote transfer key is stuck—The remote VLOC transfer

switch is stuck in the enabled (or “pressed”) state. Try pressing the

switch again to cycle its operation. If the message persists, contact your

GARMIN dealer for assistance.

VLOC transfer key stuck—The

key is stuck in the enabled (or

“pressed”) state. Try pressing the

key again to cycle its operation. If

the message persists, contact your GARMIN dealer for assistance.

Waypoint already exists—The name you have entered for a user

waypoint already exists in memory.

Waypoint(s) have been replaced—One or more user waypoints

were updated during a unit-to-unit crossfill operation.

Waypoint memory is full—You have used all 1000 user waypoint

locations in the GNS 430’s memory. Delete unwanted waypoint to

make room for new entries.

WGS 84 datum has been selected—The system map datum was

changed to WGS 84 because the selected map datum was removed

from the current NavData® card (database update), the data card is

missing or the data card has failed.

190-00140-00.indd 172 5/7/2003, 5:18:40 PM

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 203 204

Comments to this Manuals

No comments

Garmin GNS 430 User Manual Page 180

Comments to this Manuals

Related products and manuals for GPS receiver Garmin GNS 430