62 GPSMAP 3205 Owner’s Manual
MaIn Menu > sYsteM tab
Network
You can select the method to upload or download user data on networked MFDs.
•
Merge User Data—merges the user data for all MFDs on each MFD.
•
Clone User Data—the user data from the MFD initiating the clone
replaces the user data on all other MFDs attached to the network.
NMEA Interface
If you are going to use the GPSMAP 3205 with a NMEA device (such as a
radio or autopilot), the unit needs to be set to input/output NMEA data. See the
GPSMAP 3205 & GPS 17 Installation Instructions for information on wiring and
NMEA data.
To activate the NMEA data:
1. Highlight the Port 1 or Port 2 eld, and press ENTER.
2. Highlight NMEA In/NMEA Out, and press ENTER.
When transferring data between two Garmin units, always set one to Host, and
use the other unit to send or request the data.
Advanced NMEA Output Setup
The GPSMAP 3205 NMEA data transmission can be customized to change the
precision of the Lat/Lon minutes, set up the waypoint IDs, and keep the output
rate at two seconds. If the unit is set up to output all of the available NMEA
sentences, the output rate may exceed two seconds.
Use the Advanced NMEA Setup Page to turn the GPS status (GSA, GSV),
Waypoint/Route (WPL, RTE), and the Garmin proprietary sentences on or off.
Check any other equipment’s owners manual to see what sentences are required
to be enabled for functionality.
Lat/Lon Minutes Precision
allows you to adjust the number of digits to the right
of the decimal point for transmission of NMEA Output, either 2, 3, or 4 digits.
Use the Waypoint ID setting to choose to output the waypoint identiers as
names or numbers.
Advanced NMEA Setup Page
Comments to this Manuals