Garmin GPSMAP 2210 User Manual Page 98
- Page / 106
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
90 GPSMAP 2206/2210 Owner’s Manual
APPendIx > MessAges And AlArMs
Messages and Alarms
The GPSMAP 2206/2210 uses an on-screen message system to notify you of
events and alert you to problems. Press QUIT to acknowledge a message.
Accuracy Alarm—the GPS accuracy has fallen outside of the user-set value.
Alarm Clock—the alarm clock has sounded.
Anchor Drag Alarm—you have drifted out of the specied distance range.
Approaching Turn—you are nearing a turn in a route.
Approaching <Waypoint>—you are a specied distance from a destination
waypoint.
Arrival At <Waypoint>—you have arrived at the destination waypoint.
Battery Alarm—battery voltage has fallen below the value specied in the
Battery eld on the Alarms tab.
Battery Voltage Is Too High
—too much input voltage; the unit will shut off in
10 seconds. Decrease the input voltage to less than 32 volts.
Boat is not Moving Fast Enough to Calibrate—the boat is not moving fast
enough for the speed wheel to provide a valid speed.
Can’t Read User Card—error reading card; remove and reinsert. Contact your
dealer or Garmin Product Support if the problem persists.
Can’t Read Voltages That High, Limited To Top Of Range
—voltage range
must be between 10.0 and 33.0 volts for the GPSMAP 2206/2210.
Can’t Read Voltages That Low, Limited To Bottom Of Range
—voltage range
must be between 10.0 and 33.0 volts for the GPSMAP 2206/2210.
Can’t Send Waypoint—the unit cannot transmit the waypoint using the NMEA
WPL sentence. Check the wiring.
Can’t Unlock Maps—the data on the data card is not unlocked for the unit.
Contact your dealer or Garmin Product Support.
Can’t Write User Card—error writing to the card; remove and reinsert. Contact
your dealer or Garmin Product Support if the problem persists.
Database Error—internal problem with the unit. Contact your dealer or Garmin
Product Support to have the unit serviced.
Deep Water Alarm—the depth has changed by the amount of the Drift Alarm
value.
Directory Item With This MMSI Already Exists—the MMSI number is already
in the DSC directory. Use a different number.
Directory Memory is Full Can’t Create Entry—the DSC directory has reached
the maximum of 100 contacts. Delete unneeded contacts to add new ones.
Distress Call—a DSC distress call has been received. Take appropriate action.
Drift Alarm—the depth has changed by the amount of the Drift Alarm value.
Fish Alarm—shows an icon and beeps (if enabled) when a sh is detected. This
alarm does not show a message banner.
Invalid MMSI—enter a valid MMSI.
Lost Remote GPS Connection
—there is a problem with the GPS antenna
wiring. Check the connections.
Lost Satellite Reception
—the unit has lost satellite signals. Check the antenna
connections or try moving to a location with a clear view of the sky.
NMEA Depth Is Below Transducer—you must enter an appropriate Keel Offset
for the transducer.
No Proximity Waypoints/Routes/Tracks/User Waypoints Found—you
attempted to transfer user data from a data card that does not contain the specied
type of data. Make sure there is data to transfer on data card.
None Found—no data matched the search criteria.
- 2206/2210 1
- IntroductIon 3
- Product Registration 7
- Software License Agreement 7
- Warnings 8
- Important Information 8
- GettInG started 9
- 0!'% 10
- &).$ 10
- Status Bar 11
- Using Soft Keys 11
- Adjusting the Backlight 12
- Initializing the GPS Receiver 13
- Receiver Status and Accuracy 14
- GPS Setup 14
- Using Simulator Mode 15
- Using the GPSMAP 2206/2210 16
- Data entry 17
- Soft keys 17
- Using Additional Map Data 18
- Using the Map Pointer 18
- Finding an Item 20
- Creating and Using Waypoints 21
- Creating Waypoints Manually 22
- Moving a Waypoint 24
- Using Waypoint Lists 25
- User Waypoints 25
- Proximity Waypoints 26
- Navigating to a Destination 27
- TracBack Tips 30
- Man OverBoard (MOB) 31
- Creating and Using Routes 31
- Navigating a Saved Route 32
- Creating a Quick NAV Route 33
- Copying a Route 33
- Deleting a Route 34
- Editing a Route 34
- To add points to a route: 35
- Planning Routes 37
- MaIn paGes 38
- Conguring Main Pages 39
- Using Function Windows 41
- Map Page 42
- Selecting Map Ranges 43
- Cartography 44
- Map Page Options 45
- Map Page with Detail Hidden 46
- Map with Detail Shown 46
- Spot soundings 46
- (BlueChart data) 46
- Map Split Page 47
- Compass Page 48
- Highway Page 49
- Showing or Hiding Cartography 50
- MaIn Menu 51
- Tide Tab 52
- AIn Menu > tIde tAb 53
- Current Sub Tab 54
- Celestial Tab 55
- Trip Tab 56
- Points Tab 57
- Routes Tab 58
- Tracks Tab 58
- Saved Sub Tab 59
- Review DSC Waypoint 61
- Card Tab 62
- Messages Tab 63
- Alarms Tab 64
- System Alarms 65
- Nav (Navigation) Alarms 65
- System Tab 66
- Units Sub Tab 67
- AIn Menu > systeM tAb 68
- Time Sub Tab 69
- Comm (Communications) Sub Tab 69
- MAIn Menu > systeM tAb 70
- Update Sub Tab 71
- Network Tab 72
- Pages Tab 72
- Pages Tab with Removed Pages 73
- Prefs Sub Tab 74
- Detail Sub Tab 75
- Labels Sub Tab 75
- Nav Sub Tab 76
- AIS Sub Tab 76
- Source Sub Tab 77
- Temp (Temperature) Tab 78
- Sonar Tab 79
- Highway Tab 79
- Understanding Sonar 80
- Fish Symbols Turned On 81
- Hard Structure Soft Structure 81
- Sonar Page 82
- Conguring the Sonar Page 83
- Depth line 85
- General Sub Tab 87
- Graph Sub Tab 88
- Water Temp Sub Tab 89
- Specications 90
- What is WAAS/EGNOS? 92
- What is DSC? 93
- LORAN TD System 94
- Cleaning the Case 95
- Cleaning the Screen 95
- Water Immersion 95
- Navigation Terms 96
- PPendIx > nAvIgAtIon terMs 97
- Messages and Alarms 98
- Optional Accessories 100
- Limited Warranty 101
- FCC Compliance 102
- See MMSI 104
- See WAAS 105
Related products and manuals for Computer hardware Garmin GPSMAP 2210
Computer hardware Garmin GPSMAP 5215 User Manual
(116 pages)
(116 pages)
Computer hardware Garmin GPSMAP 182C User Manual
(126 pages)
(126 pages)
© 2020, manymanuals.com. All rights reserved. | 0.086 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals