Garmin GPSMAP 2210 User Manual download pdf (Page 91)

GPSMAP 2206/2210 Owner’s Manual 83

APPendIx > InstAllIng And reMovIng dAtA cArds

Installing and Removing Data Cards

The GPSMAP 2206/2210 uses optional Garmin BlueChart

and MapSource

data

cards. You can use optional preprogrammed BlueChart g2

™

data cards.

Insert data cards in the card slots located on the left side of the unit. You can

install or remove data cards at any time, whether the unit is on or off.

To install a data card:

1. Open the card door by pressing the locking tab on the door toward the

outside (left) of the unit and lifting the door open from right to left.

2. Insert the card into the slot, with the label facing to the right and the handle

facing toward you.

3. Push the card into the unit. It in not necessary to force the card, and

about 1/2" is still exposed when it is properly inserted. If the unit is on, a

conrmation tone sounds, and a message appears on the screen noting

the card details when the card is properly installed and accepted.

4. Close the cover until it locks.

If you insert a data card and receive a “card format not recognized” message,

remove the card and reinsert it. If the card is still not recognized, contact Garmin

Product Support or your Garmin dealer for assistance.

NOTE: Data cards are not waterproof, should not be exposed to moisture or

excessive static charges, and should be stored in the case supplied with the

card.

The rst time you insert a data card, the unit takes a few seconds to read the

card. After the data card is read, a summary page appears. Press ENTER to

acknowledge.

To remove a data card:

1. Open the card door by pressing the locking tab on the door toward the

outside (left) of the unit and lifting the door open from right to left.

2. Grasp the card handle, and pull out rmly.

3. If the unit is on, a conrmation tone sounds when the data card is

removed.

1 ... 90 91 92 ... 106

No comments

Garmin GPSMAP 2210 User Manual Page 91