Garmin GPSMAP 192C User Manual download pdf (Page 7)

GPSMAP 192C Owner’s Manual 1

BASIC OPERATION > INITIALIZING THE RECEIVER

BASIC OPERATION

Initializing the Receiver

The ﬁrst time you turn on the GPSMAP 192C, the receiver

must be given an opportunity to collect satellite data and

establish its present location. To ensure proper initialization, the

GPSMAP 192C is shipped from the factory in AutoLocate mode.

Before you initialize, make sure the GPSMAP 192C unit and

antenna have been correctly installed on your vessel according to

the instructions in the Appendix. Install the antenna in a location

with a clear and unobstructed view of the sky.

A full-screen GPS Information page is displayed after you press

ENTER to acknowledge the Warning page. The page goes away

after the unit gets a position ﬁx or you press either ENTER

or QUIT. The page can be disabled and enabled on the Main

Menu—Pages tab (see page 63).

To turn on the GPSMAP 192C:

1. Press and hold the POWER key until the power tone

sounds, then release the POWER key. The Warning page

appears while the unit conducts a self-test.

2. When the self-test is complete, press ENTER to agree and

acknowledge the warning.

The GPS Information page appears as the receiver begins acquiring

satellites.

To turn off the GPSMAP 192C:

1. Press and hold the POWER key for about 2 seconds, until

the screen is blank.

2. When the screen is blank, release the POWER key.

1 2 3 4 5 6 7 8 9 10 11 12 ... 123 124

No comments

Garmin GPSMAP 192C User Manual Page 7