60 nüvi 900 Series Owner’s Manual
Appendix
Problem/Question Solution/Answer
The touch screen is
not responding to my
touches properly.
Slide the Power key to the left and hold it for 8 seconds. Release
the Power key, and press your nger to the screen. Hold your nger
on the screen for about 30 seconds until the calibration screen
appears (white screen with “Press dot”).
I cannot get trafc
information.
Verify that you are in a coverage area. You must be in a coverage
area to get the trafc information for that area.
Verify that the FM TMC Trafc receiver is connected to the power
connector on the cradle and also connected to a power outlet
in your vehicle. (The trafc receiver is included in some nüvi
packages.)
My phone will not
connect to the nüvi.
Touch Tools > Settings > Bluetooth. Verify that the Bluetooth eld
is set to Enabled.
Make sure your phone is turned on and is less than 10 meters
(about 33 feet) away from your nüvi.
See www.garmin.com/bluetooth for more help.
How do I know my nüvi
is in USB mass storage
mode?
When your nüvi is in USB mass storage mode, a picture of a nüvi
connected to a computer is shown. Also, you should see two new
removable disk drives listed in My Computer.
My computer never
senses that the nüvi is
connected.
1. Unplug the USB cable from your computer.
2. Turn the nüvi off.
3. Plug the USB cable into a USB port on your computer and into
your nüvi. The nüvi automatically turns on and goes into USB
mass storage mode.
Ensure your nüvi is connected to a USB port and not a USB hub.
Comments to this Manuals