Garmin GPS III Plus User Manual download pdf (Page 100)

Alarm Clock—The alarm clock time that was set from

the Alarms submenu has been reached.

Approaching—You are one minute away from reaching

a destination waypoint.

Arrival at—You have reached your destination

waypoint.

Battery Power Low—The batteries are low and should

be replaced.

Data Transfer Complete—The unit has finished

uploading or downloading information to the connected

device.

Degraded Accuracy—The unit’s accuracy has been

degraded beyond 500 meters due to poor satellite geom-

etry or data quality. Check other navigational sources to

verify the position indicated.

Leg not Smoothed—The upcoming route leg is too

short for smooth waypoint transitions.

Memory Battery Power Low—The battery that sus-

tains user memory is low and should be replaced by an

authorized service center as soon as possible. Failure to

do so may result in loss of stored data, including all

user waypoints and routes.

Need Altitude for 2D Nav—The unit needs altitude

input in order to start and/or continue 2D navigation.

Need to Select Init Method—You must select an ini-

tialization method so the unit can locate satellites and

obtain a fix.

No Differential GPS Position—Not enough data is

available to compute a DGPS position.

No RTCM Input—Beacon receiver is improperly con-

nected or baud rates do not match.

Off Course Alarm—You are left or right of course,

beyond the limits set on the Alarms submenu.

Oscillator Needs Adjustment—

The GPS III+ has

detected excessive drift in its internal crystal oscillator

which may result in longer acquisition time. The unit

should be taken to an authorized GARMIN service center.

Poor GPS Coverage—The unit cannot acquire the nec-

essary number of satellites to compute a position. Try

another location with a clearer view of the sky.

Power Down and Re-init—The unit cannot calculate a

position due to abnormal satellite conditions. Turn power

off and use other means to verify the last position shown.

Try the unit again later, possibly in a differ

ent location.

The GPS III+ uses an on-screen message indicator to alert you to important

information. Whenever the message appears, press ENTER to acknowledge the mes-

sage and return to the previous page you were viewing. Messages are provided for

system status, waypoint/route editing, battery condition, etc. For your safety, pay

careful attention to all messages.

APPENDIX E

Messages

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 113 114

Comments to this Manuals

No comments

Garmin GPS III Plus User Manual Page 100

Comments to this Manuals

Related products and manuals for GPS receiver Garmin GPS III Plus