Garmin GMA 240 Installation Manual download pdf (Page 21)

190-00917-01 GMA 240 Installation Manual

Rev. D Page 3-1

3 INSTALLATION PROCEDURE

3.1 Unpacking Unit

Carefully unpack the equipment and make a visual inspection of the unit for evidence of damage incurred

during shipment. If the unit is damaged, notify the carrier and file a claim. To justify a claim, save the

original shipping container and all packing materials. Do not return the unit to Garmin until the carrier has

authorized the claim.

Retain the original shipping containers for storage. If the original containers are not available, a separate

cardboard container should be prepared that is large enough to accommodate sufficient packing material to

prevent movement.

3.2 Electrical Connections

All electrical connections to the GMA 240 are made through two 44-pin D-subminiature connectors (see

Figure 3-1

). Section 4 defines the electrical characteristics of all input and output signals. Required

connector and associated hardware are supplied in the connector kit (P/N 011-00652-00). See Appendix B

for interconnect wiring diagrams.

Check wiring connections for errors before inserting the GMA 240 into the rack. Incorrect wiring could

cause internal component damage.

NOTE

Non-Garmin part numbers shown are not maintained by Garmin and consequently are

subject to change without notice.

Table 3-1 Pin Contact Part Numbers

Manufacturer 22-28 AWG

Garmin P/N 336-00021-00

Military P/N M39029/58-360

AMP 204370-2

Positronic MC8522D

ITT Cannon 030-2042-000

Table 3-2 Recommended Crimp Tools

Manufacturer

Hand

Crimping Tool

High Density 22-28 AWG

Positioner Insertion/Extraction Tool

Military P/N M22520/2-01 M22520/2-09 M81969/1-04

Positronic 9507 9502-4 M81969/1-04

AMP 601966-1 601966-6 91067-1

Daniels AFM8 K42 M81969/1-04

1 ... 20 21 22 ... 42

No comments

Garmin GMA 240 Installation Manual Page 21