Garmin STYLUS NX125 User Manual

Browse online or download User Manual for Printers Garmin STYLUS NX125. Garmin STYLUS NX125 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Start Here
2 Lower the output tray, then open the extension.
3 Flip the feeder guard forward.
4 Squeeze the edge guide and slide it to the left.
5 Load paper against the right edge guide and behind the
tab, with the printable side face up.
4 x 6
8½ x 11
Read these instructions before using your printer.
1
Unpack
Power cord
Epson Stylus NX125/127
Series
Quick Guide
Basic Copying, Printing, and Scanning
Maintenance
Solving Problems
®
Caution: Do not open the ink cartridge package until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
2
Turn on
1 Connect the power cable.
Caution: Do not connect to your computer yet.
2 Press the power button.
3
Install ink cartridges
1 Open the document cover, then open the ink cover.
Caution: Don’t try to remove the ink cartridge guard or you may
damage the printer.
2 Shake the ink cartridges, then unpack them.
3 Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals from the cartridges.
4 Insert the cyan ink cartridge, and press it down until it clicks.
5 Press the stop button. The cartridge holder moves.
6 Repeat steps 4 and 5 for other cartridges.
7 Close the ink cover, then close the document cover and
press the stop button again.
8 Ink priming takes about 2 minutes. When the green power
light stops blinking, priming is complete.
Note: Your printer ships with full cartridges and part of the ink
from the first cartridges is used for priming the printer.
Caution: Don’t turn off the printer while it is priming or you’ll
waste ink.
4
Load paper
1 Open the paper support, then pull up the extension and tilt
it back slightly.
Epson Stylus
®
NX125/127 Series
4119074 Rev.0
1-F C
4119074 Rev.0
1-F M
4119074 Rev.0
1-F Y
4119074 Rev.0
1-F K
Page view 0
1 2 3 4

Summary of Contents

Page 1 - Start Here

Start Here2 Lower the output tray, then open the extension.3 Flip the feeder guard forward.4 Squeeze the edge guide and slide it to the left.5 Loa

Page 2

Start Here2 Lower the output tray, then open the extension.3 Flip the feeder guard forward.4 Squeeze the edge guide and slide it to the left.5 Loa

Page 3 - Any questions?

2 Insert the Epson Stylus NX125/127 Series software CD. Windows: If you see the AutoPlay window, click Run SETUP.EXE. If you see a User Account Cont

Page 4

2 Insert the Epson Stylus NX125/127 Series software CD. Windows: If you see the AutoPlay window, click Run SETUP.EXE. If you see a User Account Cont

Comments to this Manuals

No comments