• Mount the transducer so it does not obstruct the motor from
its storage cradle or prevent the motor from being stowed
and deployed correctly.
Assembling the Trolling-Mount Hardware
1
Attach the transducer mount bracket
À
to the transducer
Á
using the included 7 mm M4 mounting screws
Â
and M4 lock
washers
Ã
.
2
Attach the transducer mount bracket to the trolling mount
bracket
Ä
using the included 16 mm M8 bolts
Å
, M8 flat
washers
Æ
, and M8 lock nuts
Ç
.
Attaching the Transducer to a Trolling Motor Shaft
1
Insert the hose clamps
À
through the slots on the trolling
motor mount
Á
.
2
Slide the hose clamps around the trolling motor shaft
Â
.
3
Tighten the hose clamps.
4
Secure the transducer cable to the shaft or other secure
location.
5
Route the Ethernet cable to the installation location of the
network switch or to the back of the chartplotter.
NOTE: The cable should not be routed close to electrical
wires or other sources of electrical interference.
6
Route the power cable to a 12 Vdc power source.
7
Adjust the mount so it points toward the front of the boat at
an angle based on the transducer angle considerations.
Attaching the Transducer to a Trolling Motor
1
Insert the hose clamps
À
through the slots on the trolling
motor mount
Á
.
2
Slide the hose clamps around the trolling motor
Â
.
3
With the motor placed as close to the center line of rotation
as possible, tighten the hose clamps.
4
Secure the transducer cable to the motor shaft or other
secure location.
NOTE: Ensure the trolling motor and transducer clear the
boat during deployment and retraction.
5
Route the Ethernet cable to the installation location of the
network switch or to the back of the MFD while taking these
precautions:
• The cable should not be routed close to electrical wires or
other sources of electrical interference.
• The cable must not be pinched when the trolling motor is
deployed and retracted.
• Cutting the cables is not recommended, but a field
installation kit can be purchased from Garmin or a Garmin
dealer if cutting the cables is necessary.
6
Add cable wraps to secure the cable, and provide a circular
service loop to allow the trolling motor to rotate.
7
Route the power cable to a 12 Vdc power source.
8
For a downward-facing transducer, adjust the mount so the
transducer points straight down.
9
For a forward-facing transducer, adjust the mount so the
transducer points toward the front of the boat at an angle
based on the transducer mounting angle considerations.
Specifications
Specification Measurement
Dimensions (W x H x L) 9.1 x 4.2 x 17 cm (3.6 x 1.7 x 6.7 in.)
Weight 800 g (1.8 lb.)
Max. power usage 10 W
Temperature range • Operating: From 0 to 40°C (from 32 to
104°F)
• Storage: From -40 to 70°C (from -40 to
158°F).
Material ASA plastic
Maximum depth* 91 m (300 ft.)
Frequency 417 kHz
* Dependent upon transducer placement, water salinity, bottom
type, and other water conditions.
3
(8 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals