Garmin G1000 Cockpit Reference Guide for the Quest Kodiak 100
190-00645-02 Rev. A
Appendix
91
Flight
Instruments EIS
Nav/Com/
XPDR/Audio GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features
Abnormal
Operation Annun/Alerts Appendix Index
7)
Repeat steps 1-6 for the remaining displays.
8)
Verify the effectivity of the active navigation database in each PFD and the
MFD on the AUX-System Status Page.
AUTOMATIC DATABASE SYNCHRONIZATION
The automatic database synchronization feature automatically transfers the database
from a single SD database card to the SD cards on each PFD and the MFD to ensure
that all databases are synchronized throughout the system. After power-up, the system
compares all copies of each applicable database. If similar databases do not match, the
most recent valid database is automatically copied to each card in the system that does
not already contain that database.
NOTE:
The 9-arc second terrain database may take as long as 100 minutes to
synchronize using this method. Therefore the user may want to transfer the data
using a PC, or connect the system to a ground power source while performing
the database synchronization.
Synchronizing Databases
1)
Remove the MFD database card from the bottom card slot of the MFD.
2)
Update the Garmin databases on the MFD card.
3)
Insert the MFD database card into the bottom card slot of the MFD.
4)
Apply power to the system, check that the databases are initialized
and displayed on the power-up screen. When updating the terrain and
FliteCharts databases, an ‘in progress’ message may be seen. If this
message is present, wait for the system to finish loading before proceeding
to step 5.
5)
Acknowledge the Power-up Page agreement by pressing the ENT Key or
the right most softkey.
6)
Turn the large FMS Knob to select the AUX Page group on the MFD.
7)
Turn the small FMS Knob to select the System Status Page.
8)
Make sure the SYNC DBS Softkey is in the enabled state.
9)
Monitor the Sync Status in the Database Window, wait for all databases to
complete synching.
10)
Remove and reapply power to the system, select the AUX-System Status
Page, and verify that all databases have been synchronized.
Comments to this Manuals