Garmin GPSMAP 60CS User Manual download pdf (Page 11)

GPSmap 60CS

Installing the Batteries

The GPSmap operates on two “AA” batteries (not included), which are

located in the back of the unit. Alkaline or NiMH batteries may be

used (see page 55 for setting the battery type). Stored data is not lost

when batteries are removed.

o install batteries:

1. Remove the battery cover from the

back of the unit. Turn the D-Ring 1/4

turn counter-clockwise and pull out.

2. Insert the batteries, observing the

proper polarity. A polarity diagram

can be found molded into

the battery compartment.

3. Reinstall the battery cover by inserting

the bottom slot over the tab at the

base of the unit and reinserting the

locking pin in the back of the unit.

Turn the D-Ring 1/4 turn clockwise

to lock in place.

Battery Installation and

Start Up

Important Note

When replacing batteries, use only new or fully charged bat-

teries. Do not mix Alkaline and NiMH batteries. Recharge-

able batteries may typically display less capacity than

disposable batteries.

Remove the batteries from the unit if you don’t plan to

use it for several months. Storing batteries in the unit for

prolonged periods may result in leakage and damage to the

battery compartment.

Follow the manufacturer’s instructions for proper care and

disposal of used batteries. Do not incinerate used batteries,

as internal materials may ignite with explosive violence.

Extensive use of backlighting, WAAS, the electronic com

pass and key beep tones will signiﬁcantly reduce battery life.

To set backlighting intensity and timeout, see page 56.

To disable WAAS, see page 55.

To turn the compass Off, see page 15.

To mute the beep tones, see page 58.

Getting Started

Battery Compartment

USE BY: 2009

Locking

Pin Slot

1 ... 10 11 12 ... 108

Comments to this Manuals

No comments

Garmin GPSMAP 60CS User Manual Page 11

Comments to this Manuals

Related products and manuals for GPS receiver Garmin GPSMAP 60CS