Garmin GPS 45 User Manual download pdf (Page 58)

Received an Invalid WPT—A waypoint was received during upload transfer that has an

invalid identiﬁer.

Receiver has Failed—A failure in receiver hardware has been detected. If this message

persists, do not use the unit and take it to an authorized dealer for repair.

Route is Full—You have attempted to add more than 30 waypoints to a route.

Route is not Empty—You have attempted to copy into a route already in use.

Route Waypoint Can’t be Deleted—The waypoint you are trying to delete is part of a

route. You must ﬁrst delete the waypoint from the route before striking it

from memory.

Route Waypoint was Deleted—A route waypoint entered does not exist in the database

and has been deleted from the route.

RTCM Input has Failed—DGPS data being received has been lost. You are no longer

receiving the beacon signal.

Searching the Sky—The GPS 45 is in searching the sky for almanac data or the unit is in

AutoLocate

mode.

Stored Data was Lost—All waypoints, routes and almanac data has been lost due to

battery failure.

Transfer has been Completed—The receiver is ﬁnished uploading or downloading

information to the connected device.

WPT Memory is Full—You have used all 250 waypoints in the GPS 45. Delete unwanted

waypoints to make room for new entries.

Appendix B

Messages

45 manual Rev. B 8/4/98 11:11 AM Page 50

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 69 70

No comments

Garmin GPS 45 User Manual Page 58