Cylinder and Bracket Mounting InstructionsOMC 8 HP. 2 & 4 Stroke: 1993-2002Page 1PN 906-1000-00TR-1 Gold
Parts:ITEM PART No QTY. NAME3 330-1003-00 1 Pin, Stern Pivot4 380-1004-00 1 Channel, Cylinder MTG.5 370-1005-00 1 Cushion, Channel Mounting6 380-1006-
Figure 3Page 3I. Installing the Cylinder MountsTools Required: One; Wrench 9/32 In. or 7mmOne; 7/16 In. WrenchesOne; ½ In. wrenches (open end)Thread l
Step 1 (Mounting Bracket):Tip the motor all the way up. Install the Mounting Bracket Assembly (item 7) over the motor steering swivel bracket as shown
Step 3 (Remove Bolts):Tilt the motor down. Remove the rear two bolts that holds the lower vibration isolation mounting shrouds. Leave the shrouds
Step 5 (Stern Pivot Pin):Slide the Stern Pivot Pin (item 3) through the back of the Cylinder Mounting Channel (item 4) from the top.Lo
Step 7 (Cylinder End Cap):Line the hole in rear end cap of the Cylinder (item 34) with the hole in the top of the Stern Pivot Pin (item 3). Slide the
Step 8 (Full Port and Starboard):Turn the motor hard over to starboard. That will retract the Cylinder rod into the Cylinder. Check
Comments to this Manuals