Garmin NavTalk GSM User Manual download pdf (Page 11)

Getting Started

Section 2

Battery Installation

Battery Installation and Charging

The unit is powered by a Lithium Ion rechargeable battery located on

the back of the unit. The battery does not require removal from the unit

for recharging. Charging at “Start Up” may require up to three hours. The

battery is already installed on the unit, but must be removed in order to

remove the insulating strip from the contacts on the battery which prevents

complete discharge of the battery during shipping.

Battery Installation/Removal

1. Turn the unit over and use your index ﬁ nger to depress the tab in the

slot on the back of the unit to release the battery.

2. Pull the battery away from the unit and then remove the insulating strip

from the electrical contacts on the battery. Discard the strip.

3. Reinstall the battery on the back of the unit.

Charging the Battery

1. With the battery in place and the insulating strip removed from the

contacts, connect the charger (supplied with the unit) to the connector

on the base of the unit.

2. Then, connect the charger power input to an appropriate power source,

power point, etc. The unit will display a “Charging” message.

3. Allow approximately 2 to 3 hours for the initial charge and somewhat

less time for recharging thereafter. The message will change to indicate

that charging is complete.

4. The NavTalk can be operated while connected to the charger.

Battery Charging

Back of Unit

Press down on the release tab to

remove the insulating strip from

the battery contacts

Insulating Strip

Power Point

Travel Charger

Charger Plug

NavTalk Unit

NvTlkGSMManual copy.indd 1 12/2/2002, 8:41:43 AM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 129 130

No comments

Garmin NavTalk GSM User Manual Page 11